Reply to thread

Message: <blockquote data-quote="rdpmackie" data-source="post: 34476"><p>I am making my jet pack pretty damned accurate, and completely from scratch.  For the missile, I could not find any parts that were close enough to the shapes needed.  It is pretty easy to make your own custom cones.  Roll up some plastic overhead projector paper into the exact cone angle you want, coat the inside with bondo, fiberglass resin, latex or whatever will dry to hold the shape.  Cut the ends off to the desired diameter and that's it custom cones.</p></blockquote><p></p>

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification