Reply to thread

I will try to dig up the blue prints I used.  It was about a year ago but it was in CAD.  If someone just wanted one, they could go to home depot and buy an aluminum plate and some blades for a jig saw and cut it out themselves.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top