not exactly Mandalorian....

Duran Lomax

Active Hunter
...but I was wondering if anyone had any tips on creating a curved lightsaber hilt, similar to that of Count Dooku. I don't plan on using it for actual combat... it's more of a display item; "Look, I built this." Thank you, in advance :)
I agree it is a sucky model but th epoint is that it's a starting point like th esabers on Big Yellow Box. it gives you a method of starting then you improve upon it. I'll take this case as an example. I'd use a sink tailpiece cut off so it's not too long as my starting point and use that elbow joint he has there and maybe a buttcap to round it off, that'd be about acurate if you dress it right.
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.