Reply to thread

i've read on here about using a 12" craft hoop for the flair. cut it in half and glue it in on the bottom of the inside. if you do a search for helmet flair, or craft hoop/ring you should be able to find something with more detail. i'm finishing up my dp '96, i didn't change the flair, it was alright for a first helmet.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top