Reply to thread

Hi all first post here...I'm saving my pennies for a Bobamaker new cast but in the meantime I want to get my painting technique down by practicing on my DP95, but I'd like to modify it a bit to get more flare and round off the dome a bit (it looks almost flat across the top).  What is the best way to do this? My cable remote control is the perfect width to give the flare I want when I put it across inside the helmet...I heated it with a hair dryer but eventually it goes back to the original shape so is there a trick to getting it to stay?  Also any recommendations on the dome?  I have my paints ready, dremel charged up, face shield for the t visor, and a brand new pack of sandpaper and I'm chomping at the bit to get started but I want to get the shape right first before I start hacking out the visor area...any hints tips and suggestions welcome thanks a ton!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top