Reply to thread

It's a little 12V micro fan from Radio Shack - runs off the 9V battery okay. 


The padding is just foam blocks (packing from a box of hard disks) cutup and covered in material which I got at the local fabric store.  I cut out material pieces a little bigger than the foam and hotglued the sides over the foam and then hotglued the pads to the inside of the helmet.


Del


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top