Reply to thread

Message

I actually didn't make a harness, although it's a very neat concept in order to keep the plating down. I used sintra as a base and styrene strips to make that outer lip edges that the leather gets pulled over. And the top part of the armor that you see with the lettering is styrene. Therefore, raised lettering comes out when you put it on top of the sintra base. I won't make that for people cause everyone has different upper body sizes that could change the whole appearance. Talk about custom -ugh.

[QUOTE="Zam I Am, post: 64003, member: 165"] I actually didn't make a harness, although it's a very neat concept in order to keep the plating down. I used sintra as a base and styrene strips to make that outer lip edges that the leather gets pulled over. And the top part of the armor that you see with the lettering is styrene. Therefore, raised lettering comes out when you put it on top of the sintra base. I won't make that for people cause everyone has different upper body sizes that could change the whole appearance. Talk about custom -ugh. [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification