Reply to thread

I've got an XLR > 3.5mm adapter. From what I've read, most of these won't work. I'm using the Rode VXLR+ (only the + version works). That's connected to the receiver of my wireless microphone, so if you have a wired setup, you just plug your mic in there. Then, I've got a male to male cable running from the headphones out on the VE-5 to the Mic in on the Aker.


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top