Reply to thread

I went with a rough 150-180 to get most of the topical paint off, then went back over it with 0000 steel wool. Used a plastic bonding primer, either rustolium or krylon, don't remember which, hit it with a coat or two of silver base then let the stenciling begin.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top