Reply to thread

Message

o i do so hope this works for yea bro. I'm no WoL, and would greatly respect any criticizem (ok ok engineer not english major!). I sugest you cut the paper out and size it on yourself first, yea i did the WoL thing and all you do is print it and it should be the right size. if its to big, let me know, let me know what tweeking needs doing and the inches if possable. I used Adobe Photoshop and WoL templates..... i do sure hope it turns out OK for yea!

i don;t know if they will print the right size.. o well give it a shot if not then PM me
ok look down, turns out i can zip the things!!

[QUOTE="Marx Tandish, post: 99944, member: 1536"] o i do so hope this works for yea bro. I'm no WoL, and would greatly respect any criticizem (ok ok engineer not english major!). I sugest you cut the paper out and size it on yourself first, yea i did the WoL thing and all you do is print it and it should be the right size. if its to big, let me know, let me know what tweeking needs doing and the inches if possable. I used Adobe Photoshop and WoL templates..... i do sure hope it turns out OK for yea! i don;t know if they will print the right size.. o well give it a shot if not then PM me ok look down, turns out i can zip the things!! [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification