Reply to thread

Various stages of the helmet. After finishing with the base, I gave it a coat of resin to harden it up. Then the top got layers of P38 (car body filler here in the UK)


[ATTACH=full]131633[/ATTACH]


[ATTACH=full]131634[/ATTACH]


[ATTACH=full]131635[/ATTACH]


[ATTACH=full]131636[/ATTACH]


Thin layers every time followed by vigorous sanding.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top