Reply to thread

Thanks Ruze! ;)


There's that way, or go into the 3D model options, and select scale down by 10%. Do this as many times as you need to. Or scale it up by 10% if you go too far. ;)


For these options though you need Pepakura Designer. The Viewer program will not allow this. ;)


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top