Reply to thread

Morning guys!

 

I know I said I'd have this uploaded by the end of the day yesterday, I was hoping to have had the Arena pack ready too to release them both lastnight. Unfortunately I ran out of time, then to top it off my connection died and I couldn't even upload the helmet. :(

 

I'll have the Arena pack done shortly(this morning) so I'm making the helmet available now! :D

 

I've scaled this to 27cm(height) but being pepakura, it can easily be rescaled before printing so if for example you had a kid and wanted to make him/her a helmet, then you could. ;) Also, I didn't know the height of an actuall 1/1 helmet.

 

Get them here:

 

[ATTACH]12966[/ATTACH]


[ATTACH]12967[/ATTACH]

 

Hope you like them, and if there are any prblems don't hesitate to ask or mention them. ;)


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top