Reply to thread

I just received a new resin cod piece yesterday. As I was trimming and sanding it, I noticed what looked like a place where it looks like a hole "should be" on either side of the cod. I should drill those out as that's where the cod attaches to the lower back/butt plate, correct? Anyone off the top of their head, know what diameter drill bit I should use? Thanks.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top