New boy---checking out the plans before i commence the task.

Thread starter Darren
Start date Nov 29, 2019

Darren

New Hunter

Nov 29, 2019

Hi All,

Been on site for a while (as RPF too)
Just looking at all this excellent workmanship.
Been reviewing all the data and reading all the threads, I am toying with (well 75 per cent ) on manufacturing a HIC.
I have a quick question..
The top and bottom panels...how far are they recessed into the main body, I cant seem to find a dimension.

Will start to add some more posts at some point to show you progress. Think its time to step up to the builders task!

Best regards

Darren

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.