Reply to thread

Here is the pic Cruzer, I have it confirmed that the way I have it sitting now is how it needs to go together (specifically the "F" side is what I was having mental problems with)

(thankfully I was able to get apart the pieces that I had glued together.)


I have since been told by the man himself to "glue the thin styrene strip BEHIND the vacuformed piece that the F's are glued to.  You just need to trim a channel 1/16" thick, the same thickness as the extra styrene, so the side pieces sit flush with the front shells."


So I will be looking at them tonight to ensure I understand the final set of instructions.


Also publicly I want to say thanks to BKBT for listening to my ramblings and helping me out eventhough I got these third hand. :cheers


[ATTACH=full]4518[/ATTACH]


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top