Need some RS voice amp help PLEASE


Active Hunter
Need some RS voice amp help PLEASE!!!!

I need some help with my RS voice amp. I have cut it apart down to this so far:

I want to put the control board in the helmet and the battry pack in my belt. Not sure where to put the speaker yet. I need to know what to reconnect the wires once I cut them. I know the red and black ones go to the speaker. I see the white one goes to the battery board but it's the blue, green and grey ones that I am unsure of and since the AC port is no longer needed what gets connected to what?
Last edited by a moderator:
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.