Reply to thread

Looks pretty cool. Since it looks like and was designed as a bladed tonfa, perhaps you can use that to your advantage. Many police department and Army surplus or martial arts supply stores may carry an already made holster to hold the weapon for you. I would go with a type of loop holster that the blade will slide through, giving you alot more range of motion than using a full length leather/pleather sheath for it. Don't you think? I'd also use epoxy, the heavy duty stuff. I've attempted to use Welder adhesive and Goop this week, which everyone swears by, I wasn't that impressed with either sadly-even after waiting the 24 hours plus to cure. So use epoxy, it should hold it together quite well...Good luck-and lets see some pics once you're done!

 

Happy Holidays!


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top