Reply to thread

Message

I found a GI joe Sigma 6 Snake Eyes action set and I was thinking about using the enclosed (sword)
[ATTACH=full]81619[/ATTACH]
but I wont be using it as a sword. I am thinking about taking out the cheap plastic blade and trying to find a peace of PVC that is the right diameter to fit snug in the handle
[ATTACH=full]83535[/ATTACH]
and then drill holes down the length of the PVC to allow the light the hilt creates to come through. My question is what do you think is the best way to attach it to the handle (epoxy)? and also what do you think is the best way to holster it to my costume??
here is a final pic of it taken apart.
[ATTACH=full]81620[/ATTACH]

[QUOTE="morpheus1977, post: 100591, member: 1390"] I found a GI joe Sigma 6 Snake Eyes action set and I was thinking about using the enclosed (sword) [ATTACH=full]81619[/ATTACH] but I wont be using it as a sword. I am thinking about taking out the cheap plastic blade and trying to find a peace of PVC that is the right diameter to fit snug in the handle [ATTACH=full]83535[/ATTACH] and then drill holes down the length of the PVC to allow the light the hilt creates to come through. My question is what do you think is the best way to attach it to the handle (epoxy)? and also what do you think is the best way to holster it to my costume?? here is a final pic of it taken apart. [ATTACH=full]81620[/ATTACH] [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification