Reply to thread

I am not sure if this is the right section to ask but I thought I would try.  I FINALLY started my custom mando last night and of course I wanted to work on my helmet. I am using a Rubies Jango, I have the original T visor cut out but it got pretty munched up in the process so it wont make a good pattern for the new T visor.  Does any body know if there is a pattern I can down load and print out I can use on my welding shield when I pick it up today. I am hoping to have my bucket completed this weekend.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top