Reply to thread

I wish I could get mine from Zenix, but I'm using 3D printed panels and they are a bit off from the

Volvo panel so they will not fit in Zenix's box. I've edited the panel openings on the files from the

yahoo group to fit my panels, but I'm having trouble getting them printed.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top