Reply to thread

My advice would be to reinforce any areas that you anticipate will want to flex.  I did this with very small (and light) strips of wood and epoxy. Once the flex is gone, Bondo is the best choice for anding and shaping.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top