Reply to thread

[ATTACH=full]213359[/ATTACH]

3D printed pieces of beauty! Honestly most of these I printed a while ago, but it's time to get to work on em! I used a layer height of 0.3mm so lots and lots of sanding to do! oh yes bondo and filler primer too


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top