Reply to thread

Message

I managed to get some gluing going, I might want to thin out the center fronts of the chest plates a bit to flatten them some more, but I used a less resilient glue to glue the back sides of the plates. They consist of two plates for both sides; a leather covered frame and a hard pvc (not sintra) plates with Mabari inscriptions. I opted to use white leather for everything (with the exception of suede, since it's awful to dye) so I can get an overall finish similar to the screen used costume.

[ATTACH=full]212718[/ATTACH]

[ATTACH=full]212719[/ATTACH]

[QUOTE="Cookiedala, post: 513928, member: 15632"] I managed to get some gluing going, I might want to thin out the center fronts of the chest plates a bit to flatten them some more, but I used a less resilient glue to glue the back sides of the plates. They consist of two plates for both sides; a leather covered frame and a hard pvc (not sintra) plates with Mabari inscriptions. I opted to use white leather for everything (with the exception of suede, since it's awful to dye) so I can get an overall finish similar to the screen used costume. [ATTACH type="full"]212718[/ATTACH] [ATTACH type="full"]212719[/ATTACH] [/QUOTE]

This thread is more than 8 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification