Reply to thread

Yep, i was wondering what you used as a base for your gauntlets. DCB used a plastic cup and cut out the bottom. Yes, the final would be fiberglass, like the helm, can't be vac'd,  of course. I am not talking about the casting, but what did you sculpt/make your primary original with? I was just fooling around with bondo, and it's yucky fumes, and unless you are a quick cake decorator, seems sorta useless. But it's supposed to be able to be sanded smoothed etc, after the initial pasty phase. I worked with other stuff before, but thought I would change up my primary material just to see what else would be neat to work with and what would work together.


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top