Reply to thread

I've finally put primer on my new armor, taken off my first Fett molds.  I was also able to get the back armor to match up with the neck armor, bolted.  I can't wait to start painting!



And a closeup of the chest armor...


Back/neck armor attachment...


There's still some tweaking to do on the molds, the chest dents are a little out of proportion, and the outsides of the left and right chest pieces need to be more 'indented'.  At this point, I'll have to wait until AFTER DragonCon to do that.


Comments and friendly critisism welcome...    :)


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top