Reply to thread

Been playing with some thermo plastics, sintra? One of many names I think...


Drew up a template for a knee pad and started hacking and heating up, some sanding needed i have some mild results withing a couple of hours. I think I will pursue this method and refine it a little...


Hopefully I will get the results I need.... I do enjoy the testing phase


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top