Reply to thread

Message

I have the harness all done, I just need to add the cross member and maybe pop a rivet through the plates and into the pipe work to keep it sat still, other than that it was fun thing to build

[ATTACH=full]140476[/ATTACH]

[ATTACH=full]140477[/ATTACH]

[ATTACH=full]140478[/ATTACH]

It was made with things I had laying around, I do like a free build

[QUOTE="Silverstalker, post: 409740, member: 8116"] I have the harness all done, I just need to add the cross member and maybe pop a rivet through the plates and into the pipe work to keep it sat still, other than that it was fun thing to build [ATTACH=full]140476[/ATTACH] [ATTACH=full]140477[/ATTACH] [ATTACH=full]140478[/ATTACH] It was made with things I had laying around, I do like a free build :D [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification