Reply to thread

Message

Check out the attached pic of the ROTJ Blaster from the MOM exhibit.

The part outlined in white is the part you see molded on yours. The part outlined in red covers that part and is actually the piece that clamps the scope to the rifle. There is a plate on each side.

The mount is actually (3) pieces. The part that wraps around the scope and the (2) clamping plates.

[ATTACH=full]4365[/ATTACH]

[QUOTE="Ripcode, post: 69856, member: 1085"] Check out the attached pic of the ROTJ Blaster from the MOM exhibit. The part outlined in white is the part you see molded on yours. The part outlined in red covers that part and is actually the piece that clamps the scope to the rifle. There is a plate on each side. The mount is actually (3) pieces. The part that wraps around the scope and the (2) clamping plates. [ATTACH=full]4365[/ATTACH] [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification