Reply to thread

Cool! :thumbsup:  

 

Hmmm... odd about the paint.  Flats usually dry very quickly!  :facepalm

 

You could make the blocks from wood or styrene.  Glue them to the gun and then drill a hole through the block into the blaster.  Countersink the hole so it doesn't show and then add the screw.  That should be a rock solid mount!


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top