Reply to thread

Stencil all of it and paint it silver. Then spray the green. Then remove the masking fluid from what is supposed to be grey and mist black lightly with the airbrush to get your gray.. Then remove what is supposed to be black and weather It black. If you look at the rear panels, the weathering also goes on the green. Don't just go off of the stencils.


Thats my two cents.


I also suggest you go to hobby lobby and get a fine tip masking fluid. Works wonders for capturing every single detail, I like it a lot better than that Humbrol one.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top