Reply to thread

Message

Thanks morpheus1977, for your comment.. I made the holes by heating up my craft knife with the heat gun till it was very hot. The found were I was going to cut into the sintra, and then pushed it though making a 10cm X mark in the Armour, on both Armour sections.. I then heated up the sintra and just pushed my Index finger though the same hole. For the Collar Armour I push from the inside outwards, and for the Back Plate Outside inwards... It's turned out very good I think. All I had to do then was paint the metal effect on all the forced surfaces to look like damaged metal.... I will now work on my Leg Armour over the next few days, and will keep you all posted....

[QUOTE="Darth Valcar, post: 107358, member: 1703"] Thanks morpheus1977, for your comment.. I made the holes by heating up my craft knife with the heat gun till it was very hot. The found were I was going to cut into the sintra, and then pushed it though making a 10cm X mark in the Armour, on both Armour sections.. I then heated up the sintra and just pushed my Index finger though the same hole. For the Collar Armour I push from the inside outwards, and for the Back Plate Outside inwards... It's turned out very good I think. All I had to do then was paint the metal effect on all the forced surfaces to look like damaged metal.... I will now work on my Leg Armour over the next few days, and will keep you all posted.... [/QUOTE]

This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification