Reply to thread

Band saw, circular saw (carbide tip blade), or jig saw.


Keep in mind that it will be slow going as compared to wood. Al heats up and then starts binding and sticking. Cut a little then let it cool, etc.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top