Reply to thread

Ok.  I got the rest of the barrel removed, and cut the inserts for the new barrel.  I'm probably going to use bondo to fill in the gap between the old and new barrel.

 

Oh, and Graeme here's the picture of the other side you wanted.


[ATTACH=full]2533[/ATTACH]


[ATTACH=full]2534[/ATTACH]


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top