Reply to thread

For dimensions I simply printed out WizardofFlight's plans at full scale and traced the parts directly off of those. 

 

I used a 4 inch PVC pipe for the center tube, and 2.5 inch ABS pipes for the fuel cells.  I was going to go with 3 inch PVC but because of the thickness of the foam board and the way I cut and folded it to have the fewest open seams to deal with (all of my folds are made by cutting a V groove out of the backside of the foamboard and folding it in on itself .. nice clean lines on the outside that way, and it only took me 3 "trial run" jp's to get to that idea) the 3 inch wouldnt fit.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top