Reply to thread

Message

Mynock, i am very glad you posted this, and put up your site. They both have helped me move my vac table project forward. The heating unit was my biggest issue, and you, with the help of xrobot, helped me realize i can get this work, so i am moving forward with my machine. I actually got a vacuum pump for it as well. 11CFM, hoping to make a 2X3 table..just not sure if i need another heater..hoping i can get the 2 to do the job!

I also wanna thank you for answering my questions via PM, you were very helpful and i thank you very much for your time in answering my newbie questions!

[QUOTE="Darth Voorhees, post: 350021, member: 2367"] Mynock, i am very glad you posted this, and put up your site. They both have helped me move my vac table project forward. The heating unit was my biggest issue, and you, with the help of xrobot, helped me realize i can get this work, so i am moving forward with my machine. I actually got a vacuum pump for it as well. 11CFM, hoping to make a 2X3 table..just not sure if i need another heater..hoping i can get the 2 to do the job! I also wanna thank you for answering my questions via PM, you were very helpful and i thank you very much for your time in answering my newbie questions! [/QUOTE]

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification