Reply to thread

Hmm, they’re not too bad...to me it looks like when she made the mould that the base plate was put on upside down and she has jus rolled with it, maybe didn’t even notice the mistake till you pointed it out.

They are not accurate, but you said you’re not too fussed on accuracy, so an easier fix is possible that the one you suggested. ( though maybe something you may not need to do it the vendor takes responsibility and offers and exchange for the correct ones they advertised or refund, full or partial.


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top