Reply to thread

Message

Don't feel too bad about the first one, Vash, that happens sometimes. What you undertook, was a very challenging task. For someone just starting out in fiberglass, You've handled building a dissasembling mold beatifully, without the benefit of an actual demonstration. That alone, is something you can be proud of. WELL DONE!

[QUOTE="judz dwedd, post: 10053, member: 76"] Don't feel too bad about the first one, Vash, that happens sometimes. What you undertook, was a very challenging task. For someone just starting out in fiberglass, You've handled building a dissasembling mold beatifully, without the benefit of an actual demonstration. That alone, is something you can be proud of. WELL DONE! [/QUOTE]

This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification