Reply to thread

Looking good.

A couple suggestions...

The grip is brass, not brown/wood.

The head of the grip screw should be on the other side. It's a machine screw only the small tip of the end should be visible (black).


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top