Reply to thread

I would give these a try, if the curve is marginally too tight/shallow, there is a slight amount of flex in 3mm acrylic which should allow it to fit. As the T-visor should be over sized to the T-slot, you should be able to adjust for any discrepencies...


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top