Reply to thread

I already pressed down the top part of the bottle greeblie so that it didn't stick up as much above the neck part. I am gonna cast pretty soon, but go on people BRING IT ON! hehe. I hope that I don't make it worse. I started getting tired last night and was making unnessesary cuts. My new tools have helped and hindered my greeblie making. Cant seem to find a tool thin enuff for crevaces. Taking a second look,Darn, I forgot to make the v point of the leg greeblie pointier. I was worried about it being too long. I actually cut 1 cm off the top part.I will be sure to do that before I bake. But any other suggestions?  BTW, thanks for posting em Dallas! :)


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top