Reply to thread

great work so far!!! i'm no expert on making molds,but i have seen carvable foam with great density which would need just thin skin of filler to smoothen out the final finish.:confused  hmm..lookin like cruzerprophouse inc.;)


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top