Reply to thread

That looks fantastic!


It gives me hope for my TD4242 kit.


Can you take a pic of the hammer area? on mine the casting is a little wonkey and I was wondering if it was just mine or a common problem.


Also, what kind of screws did you use to fasten the stalk and connector to the hand grip?


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top