Reply to thread

I'm planing on making my own blasters but I can't seem to find measurements anywhere. I'm only looking for basic measurements from a MR blaster. Grip thickness, barrel length, barrel diameter,... ect. The rest I'll be able to figure out.

 

Any help would be greatly appreciated. Thanks.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top