Reply to thread

I just purchased a MQ-1 cast to cover my key slots on my helmet. But I'm having trouble finding some super detailed photos concerning the colors of each circuit, transistor, etc. Mines a recast and I'm having trouble finding out what needs sanded down and prepared and what is part of the circuit board...So any and all photos and tutorials you may know about, it'd be greatly appreciated at a very busy time for me lately-multi-tasking just doesn't describe it... :facepalm  Thanks alot


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top