motorised RF

BobaFettSlave1

Active Hunter
I want to create a moterised (moving) RF when my aluminum rfstalk comes in. does anyone have any instructions, diagrams, blueprints or whatever for this task? I will also need a supply list.


plz help a brother out(y)





thanks

Dana
 
PM me if you need a servo for moving the RF. I have 2 that i am not using a small and a large. I have to go to class now but i can give the measurements later. Most of us use the larger one, its a little easier to glue or screw in without gumming up the gears

dan
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top