Reply to thread

What I did was to cut the indivual pieces out and paste them into Miscrosoft Word with my current templates.  Then I sized the image to match my "proven" sizes and then cut the old templates.  The belly had to go on a 17" x 11" but it's all looking good so far. :)


No problem on the support - I recognize good work when I see it.


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top