Reply to thread

Are you sure that extreme temperature change will not cause the FG to crack.  I was wet sanding my MLC knee armor (which was a bit cold) under warm water and it cracked.  I endup reinforcing with aluminum and FG.


I would be careful just in case.


Good luck...


Loranar


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top