Reply to thread

Hi Slowmo,


I'll go as far as providing free U-bars for the JPs that could be integrated to BKBT's harness & hopefully other harnesses for that matter.

But we wont be cutting the "coin bank" slits above the JP as others may use a different harness design that would have a different measurement.....or some folks may not use a harness alltogether.

Besides, those slits could easily be added in mere minutes by a Dremel :)


Mardon


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top