Reply to thread

Here we are again. My son and I are attempting to install a micro servo in the helmet, we saw this in a few threads here at TDH. After a lot of dremel time  the fit is tight but not uncomfortable. Any suggestions on placement of reciever and batteries outside of the helmet? I am afraid that it might b too heavy for him.  


[ATTACH=full]8131[/ATTACH]


[ATTACH=full]8132[/ATTACH]


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top